Table of Contents
Advertisement
10. Route the motor lead wires and support wire
through the downrod extension and the hanger
ball (Figure 6). For maximum wire clearance, the
support cable should be routed on one side of the
clevis pin and the electrical wires on the opposite
side of the pin.
11. Securely attach the downrod to the downrod
extension/hanger ball using the four 1/4 x 10mm
round head screws (supplied in the downrod
assembly bag) (Figure 6). The round head screws
must be fully tightened into the downrod
extension. A loose downrod will result with fan
assembly noise and vibration.
12. Be sure the hanger ball setscrews are securely
tighten at this time.
13. The fan comes with blue, black and white leads
that are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above
top of hangerball/downrod assembly. Cut off
excess leads and strip back insulation 1/2-inch
from end of leads.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
WARNING
!
To avoid possible electrical shock, be sure
electricity is turned off at the main fuse box
before wiring.
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for
advise, as it must be grounded for safe
operation.
IMPORTANT
Do not attach fan blades to fan assembly until the
fan assembly is securely installed to the ceiling.
Hanging the fan with blades attached may result
in damage to the fan blades.
WARNING
!
The fan must be hung with at least 7' of
clearance from floor to blades (Figure 7).
WARNING
!
Support directly from building structure.
Structure must be capable of reliably
supporting 100 pounds.
Electrical Requirements
How to Hang Your Ceiling Fan
CLEVIS PIN
HANGER BALL
DOWNROD
EXTENSION
DOWNROD
CEILING
CANOPY
Figure 6
14. Downrod assembly is now complete.
The fan hanger bracket assembly shall be supported
directly from the supporting building structure. An
electrical box is not acceptable for fan support. The
building structure must be capable of supporting a
load of at least 100 pounds. Consult a qualified
professional to determine if your installation meets the
structural requirements.
!
To avoid fire or shock, follow all wiring
instructions carefully.
Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
AT
LEAST
7'
Figure 7
6
SETSCREW
1/4 x 10mm ROUND
HEAD SCREW (4)
WARNING
CEILING
FLOOR
U.L. Model No.: CF3300
Advertisement
Table of Contents
