Select Base Unit - Denver DDP-500 User Manual

EXTENDING
ADVANCE REGISTRATION
This is practical if the base unit is placed on a high place there you not can reach it and press the
search button.
Press MENU button on the already registered handset.
1.
Press Down button until display shows BASE , Press OK button to confirm
2.
Display shows PIN :
3.
Enter the pin code (1590 from new) , Press OK button to confirm
4.
Press Down button until display shows ADD HS, Press OK button to confirm
5.
Select a four digits registration code( ex1590)when the text PIN : is displayed
6.
Press OK button to confirm
7.
Press and hold C button to standby mode
8.
Continue the registration, see page
9.
( Refer to REGISTER BASE UNIT/HANDSET step 2 to 11)

SELECT BASE UNIT

If the handset is registered to more than one base unit, you can select one base unit as a special base
unit irrespective of how m any base units are registered.
Press the MENU button
1.
Press Down button until display shows HANDSET, Press OK button to confirm
2.
Press Down button until display shows BS SELECT, Press OK button to confirm
3.
Display shows the current setting BASE: 1 ( 1= base number one, 2 = base number two ...etc)
4.
Enter desired setting base unit using the keypad digits 1-4, Press OK button to confirm
5.
Press C button to exit programming mode or press and hold C button to standby mode.
6.
- 32 -