Reset The Handset; Reset The Base Unit - Denver DDP-500 User Manual

OTHERS

RESET THE HANDSET

If this operation is performed all factory settings will be restored:
Ring signal level restored to 3
External ring signal restored to type 4
Press the MENU button.
1.
Press Down button until display shows HANDSET, Press OK button to confirm
2.
Press Down button until display shows HS RESET
3.
Press OK button to confirm
4.
Press C button to exit programming mode or press and hold C button to standby mode.
5.

RESET THE BASE UNIT

The base unit can be reset if required. If this operation is performed all factory settings will be restored:
Base units PIN-code restored to1590
Ring signal type restored to type 2
Press MENU button on the already registered handset.
1.
Press Down button until display shows BASE , Press OK button to confirm
2.
Display shows PIN :
3.
Enter the pin code (1590 from new) , Press OK button to confirm
4.
Press Down button until display shows BS RESET, Press OK button to confirm
5.
Handset display shows
6.
7. Handset display shows NOT SUB
Internal ring signal type restored to type 3
Earpiece volume restored to low
B RESET? press OK to confirm
- 37 -
All call barrier will erase
Ringer volume restored to high