Cleaning Reminder; Cleaning The Oven Door; Oven Lamp - Electrolux EEC5700 User Manual

26 www.electrolux.com
Touch
function.
Useful information:
You can use the End function to delay the
start of the cleaning procedure.
During the Pyrolysis the door is locked.
The symbol
indicator come up, until the door unlocks.
The door unlocks when the temperature
inside the oven is under safety conditions
and the Pyrolysis finishes.
During the cleaning procedure the lamp is
deactivated.

Cleaning reminder

To remind you that the Pyrolysis is neces-
sary the cleaning reminder symbol
flashes in the display after each deactiva-
tion of the appliance for the next 10 sec-
onds.
The cleaning reminder goes
out:
• After the end of the Pyrolysis
• When you deactivate it in the

11.3 Oven lamp

WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
Removing the oven door and the glass panel
to activate the Pyrolysis
and the bars of the heat
function
Basic settings (refer to "Basic
settings")
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.
1. Turn the glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4.
Install the glass cover.

11.4 Cleaning the oven door

The oven door has four glass panels. You
can remove the oven door and the inter-
nal glass panels to clean them.
The oven door can close if you try
to remove the glass panels before
you remove the oven door.
CAUTION!
Do not use the appliance without the
glass panels.
1. Open the door fully and hold the two
door hinges.