Removing The Shelf Supports; Installing The Shelf Supports - Electrolux EEC5700 User Manual

Stainless steel or aluminium
appliances:
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials, as they can
cause damage to the oven sur-
face. Clean the oven control panel
with the same precautions.

Removing the shelf supports

1

Installing the shelf supports

Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
11.2 Pyrolysis
1. Remove all accessories and remova-
ble shelf supports.
2
11.1 Shelf supports
You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
Do not start the Pyrolysis if:
– You did not remove the core
temperature sensor plug from
the socket (if supplied). In some
models, the display shows "C2"
when this error occurs.
– You did not fully close the oven
door. In some models, the dis-
play shows "C3" when this error
occurs.
2. Remove the worst dirt manually.
3.
Touch again and again until the
display shows "Pyro" and the number
of the cleaning mode.
4.
Touch or
of the cleaning procedure:
– 1 – 1:00 for a low degree of dirt
– 2 – 1:30 for a usual degree of dirt
– 3 – 2:30 for a high degree of dirt.
ENGLISH 25
to set the duration