Table of Contents
Advertisement
1
: There is an unknown satellite (when the NID lock is used for searching)
2
1
: Searching fail (clear if in normal state)
3
1
: No gyro input (refers to a communication error)(clear if in normal state)
4
1
: PCU DSP flash writing error
5
1
: PCU DSP EEPROM writing error
6
1
: Not used
7
1
: Not used
8
(3)
0x FF
=1
1
1
1
1
8
7
6
5
1
: Not used
1
1
: Not used
2
1
: Not used
3
1
: Not used
4
1
: Not used
5
1
: Not used
6
1
: Not used
7
1
: Not used
8
(4)
0x FF
0x01: System has restarted
0x02: Unknown RS232 error has occurred
0x03: Unknown or invalid command has been received
0x04: Unknown or invalid data has been received.
0x05: The 'TS:' command must be sent prior to the command.
This is for programming the transponder/satellite data.
0x06: A tuner I2C bus failure has occurred. This could indicate that the tuner is
defective.
0x07: The LNB polarity voltage is not within the LNB polarity range. This could
indicate that the LNB voltage does not change or that the LNB voltage has shorted.
0x08: The LNB signal level is below the valid range. This could indicate that the LNB
is not connected.
0x09: The E2Ram has failed
NOTE: To clear the error by perforce after checking the error, press the 'NEXT'
button on the ACU. If using the SCS, click the 'ERR' LED.
1
1
1
4
3
2
1
Table B-1 Error Code Definition
71
Hide quick links:
Advertisement
Table of Contents
