Set The Peak Trim - KNS SUPERTRACK S4 Installation And Operation Manual

Set the peak trim

Skew angle automatically calculated by PCU, but sometimes satellite has skew offset.
In this case, you have to set the peak to track the higher quality. Refer to below step
and Figure 4-10.
a. Change the skew angle on skew manual mode after select the desired satellite
that has skew offset.
b. Look at the Quality, then search higher quality by change of skew.
c. Click the 'Set To Peak', after search higher quality.
d. Click the "Peak Save' to save changed peak.
e. Then, S4's skew is moving to changed skew angle when select this satellite.
NOTE: If you want to reset the peak, click the 'Peak Reset' and click the 'Peak Save'.
Current Skew Angle
Figure 4-10 Setting Peak Trim
49
Current Signal Level(Quality)