Setting New Skew ‘0’Degree Position - KNS SUPERTRACK S4 Installation And Operation Manual

Skew Setting
When PCU is replaced, you must reset the skew '0' degree position. Refer to
below step.
a. Input desired new skew angle in manual value box.
b. Click the 'Skew Manual'
c. Confirm the new skew '0' degree position.
d. If it is correct, click the 'Reset to Zero', and if it is incorrect re-try the upper steps.
Figure 4-23 Setting New Skew '0'degree Position
NOTE: '0' degree position is aligned the LNB top side with cross pulley.
Figure 4-24 Setting New Heading offset
60