Connect To Pc; S4 Selection On Scs - KNS SUPERTRACK S4 Installation And Operation Manual

4.1. Connect to PC

After connects to the PC like Figure 3-6, runs the SCS. Press M/C and hold 3
seconds or select 'Upgrade' in setup mode.
And select the 'TVRO or A6,9 Selected after PCU V2.11' icon and click the 'OK'
button, then select the COM port of your computer, select baud rate 19200. Lastly
click the 'DISCONNECT', then S4 is connected with computer.
You can see that 'CONNECT' LED of status panel is on like Figure 4-3. Also, you
can see the current state of antenna. State of antenna is one among 'Initialize',
'Searching' 'Searching Fail', and 'Tracking', 'HALT'.
Figure 4-1 S4 selection on SCS
39