Table of Contents
Advertisement
Installing the
radio assembly
Chapter 3 • Installing the antenna and radio assembly
20
1037751-0001 Revision A
To mount the radio assembly to the tailpiece:
1. Position the radio assembly above the tailpiece so that the
waveguide end of the radio is nearest to the reflector, as
shown in Figure 13.
Figure 13: Positioning the radio
-inch ×
2. Insert two
5/16
lock washers, up through the tailpiece from underneath, and
into the threaded sockets on the bottom of the radio
transitory, as shown in Figure 14.
3. Tighten the two bolts with a wrench until secure.
-inch bolts, with flat washers and
3/4
Advertisement
Table of Contents
