Table of Contents
Advertisement
Symbols
Code 93
Select Message Length
It is used to program the valid reading length of Code 93. The engine will
send an error beep, if the decoded data length does not match the valid
length.
Code 93 Message Length is defined by "Min. Message Length" and
"Max. Message Length ."
Min Message Length
【Pro CMD：99912606】
1D bar code Message Length should not exceed 255 bytes. If Max Message Length is less
than Min Message Length, it means the engine will only support barcodes of the two lengths.
If Max Message Length is equal to Min Message Length, the engine will only support
barcodes of the length.
To set Min Message Length of Code 93 to 8 bytes and Max Message Length to 12 bytes,
read these programming codes:
1."Code Programming ON"
2."Select Min Message Length"
3. Digit Code "8", see Digit Code (Appendix Pxxx)
4."Save Programming", see Digit Code (Appendix Pxxx)
5."Select Max Message Length"
6. Digit Code "1"
7. Digit Code "2"
8."Save Programming"
9."Code Programming OFF"
nlscan.com
Max Message Length
【Pro CMD：99912607】
Tools
Code Programming ON
Code Programming OFF
Page 105
Advertisement
Table of Contents
