Soft-Off By Pwrbtn (Power Button); Wake Up On Lan 1; Power On By Ring - Advantech PCA-6289 User Manual

Socket 604 dual xeon /lv xeon full-sized processor card with pci-x/ddr/vga/ dual gbe/400 or 533 mhz fsb

Hide thumbs Also See for PCA-6289:

Table of Contents

2.6.20 Soft-Off by PWRBTN (Power Button)

Pressing the power button for more than 4 seconds forces the system to

enter the

Soft-Off state when the system "hangs". The available choices are Delay

4 Seconds, Instant Off.

When the system enters a Soft-off mode (Standby power exists but sys-

tem is not working), it will wake up system when specific signals

occurred. The BIOS monitors

the system for "activity" to determine when to enable power manage-

ment. If you enable this feature, the computer specifies that any signal

noticed on the LAN bus channel must go out from the hibernation state.

The choices: Enabled, Disabled.

An input signal on the serial Ring Indicator (RI) line (in other words, an

incoming call on the modem) awakens the system from a soft off state.

The choices: Enabled, Disabled.

Reload Global Timer Events

Primary IDE 0

Primary IDE 1

Secondary IDE 0

Secondary IDE 1

The events are I/O events whose occurrence can prevent the system from

entering a power saving mode or can awaken the system from such a

mode. In effect, the system remains alert for anything which occurs to a

device which is configured as Enabled, even when the system is in a

power down mode. The choices: Enabled, Disabled.

Chapter 2

Table of Contents