Display Function - York Fitness 53067 Owner's Manual

Key Function:
KEY DESCRIPTION
• During setup, press RESET button once to reset current setting value.
• Press and hold the RESET button for 2 seconds (the monitor will beep) to reset all
• Press the button once to add one increment to the current setting value.
• TIME setting range: 00:00~99:00 (Each increment is 1:00)
• CALORIES setting range: 0~9990 (Each increment is 10)
• DISTANCE setting range: 0.00~99.50 (Each increment is 0.5)
• PULSE setting range: 0-30~240 (Each increment is 1)
• Test your heart rate recovery. (See the "Recovery Mode" section)
• Press the MODE button to select a function for setup, the monitor will beep between
• In SCAN mode, pressing the MODE button will lock the monitor to display the current
• Press and hold the MODE button for 2 seconds to reset all values.

Display Function:

DISPLAY DESCRIPTION
SCAN • The sequence of display: RPM > SPD > TM > DST > CAL > PLS
• In SCAN mode, press MODE key to display the next functions.
• Automatically scan through each mode in sequence every 6 seconds.
SPEED • SPEED will display "0.0" if there are no signal transmitted to the monitor for 4
• Range 0 ~ 999
RPM • RPM will display "0" if there are no signal transmitted to the monitor for 4 seconds.
• Range 0 ~ 999
TIME • If the user do not setup a preset value, TM will count up during workout.
• TM will count down from your target value. An alarm will sound when it reaches 0.
• Range 00:00 ~ 99:59
DISTANCE • If the user do not setup a preset value, DST will count up during workout.
• DST will count down from your target value. An alarm will sound when it reaches 0.
• Range 0:00 ~ 99:99
CALORIE • If the user do not setup a preset value, CAL will count up during workout.
• CAL will count down from your target value. An alarm will sound when it reaches 0.
• Range 0 ~ 9999
PULSE • Hold on the hand pulse sensors and PLS will display your current pulse after
• An alarm will sound if your pulse is over the preset target.
• Range 0-30 ~ 240.
P (STOP) If there are no signal transmitted to the monitor for 4 seconds,
the monitor will display "
function values.
selection.
function.
seconds.
receiving your pulse signal for 6 seconds.
".
www.yorkfitness.com 11