Operation; Location And Description Of Controls - Meiko FV 130.2 Owner's Installation, Operation And Maintenance Manual

4 O
PERATION

4.1 Location and Description of Controls

The machine controls are located on two keypads on the front panel. See Figure 4-1.
T T
SELEC HEAVY SELEC HEAVY
SELEC SELEC T DED DED T CYCLE CYCLE
T T CYCLE EXTEN EXTEN CYCLE
NORM SELEC NORM SELEC AL AL
CYCLE CYCLE
F/82 F/82 °C °C
MIN. MIN. 180° 180°
F/66 F/66 °C °C
MIN. MIN. 150° 150°
A, B, C - POWER/CYCLE SELECT keys
These keys turn the machine on. Each key
selects a different cycle length to
accommodate differing levels of soiling:
Normal cycle (3 minutes) for plates,
glassware and typically soiled pots,
pans and utensils
Extended cycle (5 minutes) for items
with heavier soiling
Heavy cycle (8 minutes) for items
with very heavy soiling
The keys may also be pressed between
cycles to choose a different cycle length.
D - CYCLE/DRAIN key
If pressed when the unit is
ready to operate, this key
starts the operating cycle. If
the machine has been
switched off (for instance, at the end of the
shift), this key empties the tank. There are
two Cycle/Drain keys on the front of the
machine. Both keys function identically.
Figure 4-1: Dishwasher controls
D
A
MIN. 150°F/66°C MIN. 150°F/66°C
F
E - POWER OFF key
operation, this key will switch the unit off.
F - WASH TANK TEMPERATURE display
water in the wash tank.
G - FINAL RINSE TEMPERATURE display
final rinse water. The machine cannot begin
a rinse cycle until the rinse water has heated
to the proper temperature. The wash cycle
will automatically extend (if necessary) until
the proper rinse temperature is reached.
S
ECTION
B C
SELECT SELECT SELECT SELECT SELECT SELECT
NORMAL NORMAL EXTENDED EXTENDED HEAVY HEAVY
CYCLE CYCLE CYCLE CYCLE CYCLE CYCLE
MIN. 180°F/82°C MIN. 180°F/82°C
G
If pressed when the unit is in
operation, this key ends the cycle
immediately. If the unit is NOT in
Shows the current
temperature of the
Shows the current
temperature of the
4 - O
PERATION
D E
Page 13