Weekly Cleaning (Or As Required) - Meiko FV 130.2 Owner's Installation, Operation And Maintenance Manual

S 5 - C
ECTION LEANING
8. Check the inside of the wash tank for food
particles. Wipe any residue out of the tank
using a clean, damp cloth.
9. Meiko recommends that the door of the
machine be left open overnight to allow it
to air thoroughly.
10. Reassemble all components into the
machine before operation. Note that the
Active Plus filter MUST be re-installed with
the slotted end facing DOWN. See Figure
5-1.
IMPORTANT
Be sure to flip down the two angled plates
that surround the Active Plus filter before
replacing the scrap screen!
To replace the wash arms, first insert the
back end into the manifold. The back end
of the arm is keyed to ensure correct
replacement. Then, snap the front end
down into the black retainer bar. All lower
wash arms are identical.

5.2 Weekly Cleaning (or as required)

Once per week, or as required, perform the
following steps:
1. Open the doors. Follow the procedures in
Section 5.1, "Daily Cleaning."
Figure 5-2: Wash and
rinse arm disassembly
Note that upper wash arms are shorter than lower
wash arms to ensure correct re-installation.
Upper wash arm
Lower wash arm
Page 18
2. Remove and disassemble the wash and
rinse arms. The machine is equipped with:
•
•
•
•
•
Both removable rinse arms are identical.
The upper wash arms are slightly shorter
than the lower arms to prevent their re-
installation in the wrong location.
All of the lower wash arms are removed
in the same manner as described in
Section 5.1, "Daily Cleaning." To remove
the upper wash arms, first pull the front
side of the arm down and out of the black
retainer bar, and then pull the back side
free of the manifold.
To remove the rinse arms, remove the re-
taining screw and pull the arm off the shaft.
3. Clean the wash and rinse arms with a
brush and warm running water. In
particular, check that any food soil inside
the wash arms is removed.
4. Reassemble all components into the
machine.
Both removable
rinse arms are
interchangeable
Retaining
screw
Rinse
arm
Four upper wash arms (identical)
Four lower wash arms (identical)
One removable upper rinse arm
One removable lower rinse arms
Two additional fixed lower rinse arms
(leave these in place)