Ec Declaration Of Conformity - DeVilbiss GTi Operation Manual

E
E
Read and follow all instructions and Safety Precautions before using this equipment
The GTi Gravity Feed Spraygun Kit is approved to ATEX regulations 94/9/EC, protection level; II 2 G X, Suitable
for use in Zones 1 and 2
Important: These Sprayguns are suitable for use with both waterbased and solvent based coating materials. The
design uses EPA compliant atomising (Devilbiss Trans-Tech®) technology to reduce overspray and improve
coating efficiency. Nozzles and Needles are manufactured in Stainless Steel. These guns are not designed for use
with highly corrosive and/or abrasive materials and if used with such materials it must be expected that the need for
cleaning and/or replacement of parts will be increased. If there is any doubt regarding the suitability of a specific
material contact your local Distributor or ITW Finishing direct.
Example:
Aircap Number
Gunbody colour
B = blue; m = multicolour

EC Declaration of Conformity

We: ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the manufacturer of the
Spraygun model GTi-G declare, under our sole responsibility, that the equipment to which this document
relates is in conformity with the following standards or other normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the protection requirements of
Council Directive 98/37/EC relating to Machinery Safety Directive, and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective Systems intended for use
in Potentially Explosive Atmospheres protection level II 2 G X.
This product also complies with the requirements of the EPA guidelines, PG6/34. Transfer efficiency
certificates are available on request.
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
© 2003 ITW Finishing Systems and Products
Operation Manual
GTi – Gravity Feed Spraygun
Important
Description
Model Part Number
GTI-G110B-14
2
Nozzle size
B. Holt, General Manager
30th June 2003