Ec Declaration Of Conformity - DeVilbiss SRi Operation Manual

E
Read and follow all instructions and Safety Precautions before using this
The Devilbiss SRi is a small gravity-fed spray gun designed for spraying spot repairs and small
areas. It is approved to ATEX regulations 94/9/EC, protection level;
Important: These spray guns are suitable for use with both water-based and solvent-based
coating materials. The design uses EPA compliant atomising (Devilbiss Trans-Tech®) technology
to reduce overspray and improve coating efficiency. Nozzles and needles are manufactured in
stainless steel. These guns are not designed for use with highly corrosive and/or abrasive
materials and if used with such materials it must be expected that the need for cleaning and/or
replacement of parts will be increased. If there is any doubt regarding the suitability of a specific
material contact your local Distributor or ITW Finishing direct.
Example:
Air Cap No.

EC Declaration of Conformity

We, ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the
manufacturer of the Spray gun model SRi, declare, under our sole responsibility, that the
equipment to which this document relates is in conformity with the following standards or other
normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the
protection requirements of Council Directive 98/392/EEC relating to Machinery Safety
Directive, and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres protection level II 2 G X.
This product also complies with the requirements of the EPA guidelines, PG6/34.
Transfer efficiency certificates are available on request.
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
Operation Manual
Devilbiss SRi – Gravity Spray Gun
Important
equipment
Description
II 2 G X. Suitable for use in Zones 1 and 2
Model Part No.
SRi-G210B-08
B. Holt, General Manager
th
30 June 2003
2
Fluid Nozzle Size
(08 = 0,8 mm)
© 2003 ITW Finishing Systems and Products