PaceMaster Silver XRC Owner's Manual page 13

Step 5B:
Attach the Handrail (59) to the Seat Base (51)
with Bolts (114), Lock Washers (5), Flat
Washers(112), and Acorn Nuts (110). Then
tighten the bolts using the wrench (117) and
the 6mm Allen Wrench (118)
Step 5C:
Rotate the Handle (93) of the Seat
Base (51) upwards in the direction
shown in Fig A then slide the Seat
Sliding Base onto the Seat rail (84),
and then release the Handle. DO
NOT PINCH the Contact heart rate
wire when sliding the seat sliding
base (51) on to the Seat rail (84).
Step 5D:
1. Install both Plastic Seat Stops (90) to the
Seat rail (84), with Bolts (91), using the 4mm
Allen Wrench (116) (one seat stop on each
side).
2. Connect the contact heart rate Wires (17) &
(63) as shown in fig B.
Step 5E:
Install the seat rail covers (48) & (49) to the
Seat rail (84), with Self Tapping Screw (41)
using a Phillips head screw driver (117)
13