Related Manuals for PaceMaster Gold Indoor Cycle
Summary of Contents for PaceMaster Gold Indoor Cycle
- Page 1 PaceMaster Gold Indoor Cycle OWNER’S MANUAL Aerobics Inc., 34 Fairfield Place West Caldwell, NJ 07006, (973) 276-9700 www.pacemaster.com Part # IC Gold Rev. 12/21/07...
-
Page 2: Table Of Contents
Assembling Your Indoor Cycle 7-10 OPERATING INSTRUCTIONS 11-14 Seat Height and Position Adjustment 11-12 Handlebar Height and Position Adjustment Toe Strap Adjustment Resistance Adjustment PREVENTATIVE MAINTENANCE LIFETIME LIMITED WARRANTY GOLD INDOOR CYCLE EXPLODED PARTS DIAGRAM GOLD INDOOR CYCLE TECHNICAL SPECIFICATIONS... -
Page 3: Introduction
PaceMaster products have consistently received praise from a wide range of nationally recognized publications. To get the most from your PaceMaster, please read this owner’s manual carefully before starting to use this piece of exercise equipment. The manual contains important information about the assembly, operation and maintenance of the machine. -
Page 4: Important Safety Instructions
Aerobics, Inc. • Never operate your PaceMaster Indoor Cycle if it is not operating properly, if it has been dropped or damaged or if it has been immersed in water. Should any of these occur, contact your authorized PaceMaster retailer or service center for examination or repair. -
Page 5: Assembly Instructions
ASSEMBLY INSTRUCTIONS Installation Requirements Your PaceMaster should be installed indoors on a flat, level surface. You must have a minimum of 2 feet of clearance on all sides between the bike and any wall or obstruction. TIP: If you are installing your PaceMaster on a carpeted surface, use an equipment mat or a scrap piece of carpet underneath the Indoor Cycle to avoid soiling of the carpet. -
Page 6: Box Contents
Box Contents... -
Page 7: Assembling Your Indoor Cycle
Indoor Cycle Assembly Summary... - Page 8 1. Assemble the Front Stabilizer STEP 1: As shown to the Right, attach the Front Stabilizer (6) to the Frame (1) with Bolts (3), Washers (4) and Acorn Nuts (5), then tighten the nut (5) with a 13mm wrench. Note: The front Stabilizer (6) is the one that has the WHEELS ON IT, AND the wheels MUST be towards the front.
- Page 9 3. Install the Pedals STEP 3: The pedals are stamped on the threaded end of the axle with the letter “R” and “L” for Right and Left respectively. Right and Left sides are determined as you would use the indoor cycle. Install the Right pedal on the Right crank arm using a 15 mm wrench.
- Page 10 It is important that you level your spin bike before use. There are 2 adjustable leveling feet on the rear stabilizer. If your Gold Indoor Cycle is not sitting with ALL four of the feet in contact with the floor, use the leveling feet to make the...
-
Page 11: Operating Instructions
OPERATING INSTRUCTIONS Seat Height Adjustment To ensure maximum efficiency, comfort, and safety follow the steps below to adjust the seat height and position properly. To adjust the seat height, loosen the adjustment knob as shown to the right. WARNING: There is a safety STOP line engraved on the seat post. On no account should the seat post ever be raised above this line. - Page 12 OPERATING INSTRUCTIONS cont’d Seat Position Adjustment To adjust the seat position, loosen the adjustment knob as shown to the right. While seated, with your feet on the pedals, and the pedals at the 3 o’clock and 9 o’clock positions slide the seat until the forward knee is directly over the pedal axle.
-
Page 13: Handlebar Height And Position Adjustment
OPERATING INSTRUCTIONS cont’d Handlebar Height and Position Adjustment To Adjust the handlebar height undo the adjustment knob which is located in front of head tube. Slide the handlebar/stem up or down to the desired height and then retighten the adjustment knob. WARNING: There is a safety STOP line engraved on the handle bar stem. -
Page 14: Toe Strap Adjustment
OPERATING INSTRUCTIONS cont’d Toe Strap Adjustment Pedals and toe straps – your feet should be securely positioned in the toe clips during the exercise. Put your foot as far forward as you can into the toe-clip and then pull the strap tight. To release the toe strap press the inside of the metal clasp away from your foot as shown to the right. -
Page 15: Preventative Maintenance
Lifetime Limited Warranty Aerobics Inc. (“Aerobics”) warrants that this PaceMaster product is free of manufacturing defects in workmanship and materials. Aerobics will replace or repair defective parts during the warranty period. The warranty time period begins on the original date of purchase. The... -
Page 16: Gold Indoor Cycle Exploded Parts Diagram
EXPLODED PARTS DIAGRAM... -
Page 17: Gold Indoor Cycle Technical Specifications
Warranty: Lifetime Frame, 2 Years Parts, 1 Year Labor Operating Temperature Range: 50º F to 100º F Manufacturer reserves the right to change the products specifications without notice. © Aerobics, Inc. 2007 PaceMaster is a registered trademark of Aerobics Inc.