Chapter 6: Troubleshooting; Forgot My Network Ip Address; Can't Map A Network Drive In Windows Xp; Restoring Factory Defaults - Thecus N2800 User Manual

Chapter 6: Troubleshooting

Forgot My Network IP Address

If you forget your network IP address and have no physical access to the system,
you can find out the IP address by either looking directly onto the Thecus IP storage
OLED panel, or by using the setup wizard to retrieve the IP of your Thecus IP
storage.
1. Start the Setup Wizard, and it will automatically detect all Thecus IP storage
products on your network.
2. You should be able to find the IP address of the Thecus IP storage which you
have forgotten in the Device Discovery screen.

Can't Map a Network Drive in Windows XP

You may have problems mapping a network drive under the following conditions:
1. The network folder is currently mapped using a different user name and
password. To connect using a different user name and password, first
disconnect any existing mappings to this network share.
2. The mapped network drive could not be created because the following error
has occurred: Multiple connections to a server or shared resource by
the same user, using more than one user name, are not allowed.
Disconnect all previous connections to the server or shared resource and try
again.
To check out existing network connections, type net use under the DOS prompt.
You may refer the URL below for more network mapping information.
http://esupport.thecus.com/support/index.php?_m=downloads&_a=viewdownload&downloaditemi
d=57&nav=0

Restoring Factory Defaults

From the System menu, choose the Factory Default item and the Reset to
Factory Default screen appears. Press Apply to reset Thecus IP storage factory
default settings.
WARNING Resetting to factory defaults will not erase the data stored in the hard
disks, but WILL revert all the settings to the factory default values.
130