LEG ASSEMBLY
1.
With assistance, remove bed from carton and place upside down and protect the bed by using the styrofoam (FIG.1).
2.
Locate hardware (FIG.2).
3.
Match leg sections black with grey. Use detents to assist in matching. Shown in FIG.3, 3A, 3B.
4.
Place carriage bolts through backside of the black leg support and lay the grey leg on top, then screw on nuts (FIG.3
(X,Y)). Do not tighten at this time.
5.
Match this assembly with side panels ((A) refer to parts diagram pg. 9) and join using same procedure as above. Shown
assembled in FIG.4 (X,Y).
6.
Add another finish leg assembly to opposite side (FIG.5).
X
FIG.3
Y
X
Y
ASSEMBLY
FIG.1
FIG.3A
FIG.4
10
FIG.2
FIG.3B
FIG.5
FIG.3B