Table of Contents
Advertisement
WARNING
!
1. DO NOT assemble the Mortiser until you are sure
the tool is disconnected from the power source.
2. DO NOT assemble the Mortiser until you are sure
the power switch is in the off position.
HYDRAULIC CYLINDER ASSEMBLY
WARNING
!
MAKE CERTAIN THAT THE MORTISER IS DIS-
CONNECTED FROM THE POWER SOURCE.
1. Thread lower ball stud fitting into hole (B) in the
column of the Mortiser. SEE FIG. 5
Fig. 5
A
C
2. Snap the hydraulic cylinder (C) over the upper ball
stud fitting (A) on the back of the Mortiser head.
3. Attach the other end of the hydraulic cylinder to the
lower ball stud fitting installed in step 1.
ASSEMBLY
B
17
BASE ASSEMBLY
WARNING
!
MAKE CERTAIN THAT THE MORTISER IS DIS-
CONNECTED FROM THE POWER SOURCE.
1. Place mortiser column (A) over the base (B), align-
ing the four holes in the mortiser column with the
four holes in the base. SEE FIG. 6.
Fig. 6
C
2. Insert four M8 socket head cap screws (C) with
washers and lockwashers through the column.
Thread into base and tighten.
FENCE ASSEMBLY
WARNING
!
MAKE CERTAIN THAT THE MORTISER IS DIS-
CONNECTED FROM THE POWER SOURCE.
1. Insert guide rod (A) through hole in hold down (B)
and tighten set screw (C) using supplied hex
wrench. SEE FIG. 8.
Fig. 8
B
E
A
A
B
C
D
F
Hide quick links:
Advertisement
Table of Contents
