Steel City 40540 User Manual page 13

MOTOR MOUNT BRACKET ASSEMBLY
1. Locate the front and rear motor bracket supports, black and grey. FIG.6 is rear with hole for motor pulley to protrude.
Install belt guard bolts, FIG.6A into 2 holes, (FIG.6 (D)). One shown tightened.
2. Install 2 carriage bolts each side of motor support brackets, black and grey. Grey is shown in FIG.7 and FIG.7A (A,B).
Hand tighten nuts to keep secure for future use.
3. Place motor bracket (T) (refer to parts diagram pg. 9) onto upside down motor (FIG.8 (EE)) and using 4 bolts, washers,
lock washers and nuts (FIG.8A (A,B,C,D,E)). Tighten at this time.
4.
Slide motor with bracket into the support panels, grey shown (FIG.7A and FIG.10).
Locate hardware (FIG.9 (A,B,C,D,E)). Slide carriage bolt from inside motor bracket through holes (FIG.9A (E)) in front
5.
and rear support brackets and install the flat washer, lock washer and nut. Shown in FIG.9B. Do not tighten at this time.
B
A
C
E
EE
A
B
C
D
D
FIG.6
A
FIG.7
A
B
C
D
FIG.8
FIG.9
A
B
A
A
C
E
E
A
B
C
D
FIG.9A
11
C
FIG.6A
B
FIG.7A
B
D
FIG.8A
A
C
FIG.9B
D
E
B