Steel City 40540 User Manual page 20

FENCE INSTALL
1. Thread the Allen bolts (A) with flat (B) and lock (C) washers into the rear of the bed (FIG.26).
2. Position carriage slots over each bolt and level to infeed table, then tighten.
3. Line up the pointed set screws (FIG.27 (A)) with the fixed adjustable receiver (B) and make each side snug and then
tighten the nut (C) fit 27A.
4. Line up the Allen bolt (FIG.28 (A)) with hole and the fence bracket (B), insert and tighten. If the bracket does not sit flush,
you may need to adjust the pointed set screws from FIG.27 to shift the fence in the direction needed. FIG.29 shows final.
C
A
B
A
FIG.26
D
B
B
A
FIG.28
E
C
FIG.27
18
A
B
B
C
FIG.26A
A
C
FIG.27A
FIG.29