Steel City 40540 User Manual page 14

MOTOR ASSEMBLY TO LEGS
1. Using stand hardware from FIG.2, line up the left and/or right leg assembly with the upside down motor assembly. Press
leg assembly onto the carriage bolt left in place (FIG.7 and 7A).
2. (FIG.10 and FIG.10A) Install the nut (C) onto carriage bolt (D) and tighten the one closest to the motor bracket (FIG.10B)
Install the other carriage bolt from opposite side, place nut on carriage bolt and leave loose for the cross support bracket install.
3. Repeat this procedure for the opposite side.
4. Locate cross bracket and stand support (F) (refer to parts diagram pg.9). Using carriage bolts and nuts that have been
left loose in step 2 and FIG.10, install cross bracket between nut and frame (FIG.11, 11A, 11B). Bolt and nut removed for
clarity. Tighten nuts (B) now and ensure the slot in cross bracket is pointing at the motor (FIG.11B with arrow).
5. Repeat for opposite side.
A
F
FIG.10
B
FIG.10B
A
B
FIG.11
B
A
C
D
FIG.10A
F
12
B
FIG.11B
A
FIG.11A