Diagnostic Tips - HP ProCurve Series 8212zl Installation And Getting Started Manual

Diagnostic Tips:

Tip
Number Problem
➊
The power supplies
installed in the
switch are not
plugged into active
AC power sources,
or the power supply
may have failed.
➋
A switch hardware
failure has
occurred. All the
LEDs will stay on
indefinitely.
➌
The switch has
experienced a
backplane failure
during self test.
➍
The module
installed in the slot
that corresponds to
the letter that is
blinking is an
invalid module.
1. Verify the power cord is plugged into an active power source and to the switch.
Ensure these connections are snug.
2. Try power cycling the switch by unplugging and plugging the power cord back in.
3. If the Power LED is still not on, verify the AC power source works by plugging
another device into the outlet. Or try plugging the switch into a different outlet or
try a different power cord.
If the power source and power cord are OK and this condition persists, the switch
power supply may have failed. Call your ProCurve authorized dealer, or use the
electronic support services from ProCurve to get assistance. See the Customer
Support/Warranty card for more information.
Try power cycling the switch. If the fault indication reoccurs, the switch may have
failed. Call your ProCurve authorized dealer, or use the electronic support services
from ProCurve to get assistance. See the Customer Support/Warranty card for more
information.
The failure may be just in the communications with a single module slot, or it might
be more significant. Start a console session with the switch, and at the CLI prompt
issue the command show logging. In the event log that is displayed, there will
be messages that describe the extent of the problem. If the problem is with individual
slots, the remainder of the switch slots will be fully operational and can be used until
you get a chance to replace the switch.
If necessary to resolve the problem, contact your ProCurve authorized dealer, or use
the electronic support services from ProCurve to get assistance. See the Customer
Support/Warranty card for more information.
The fact that the Link and Mode LEDs never are lit on the module indicates that it is
a ProCurve Switch gl module and should not be used in your zl switch.
Ensure you have installed a zl module in the slot. ProCurve xl/gl modules
l
Z
will fit in the slot, but they are not compatible with your ProCurve zl switch.
m odule
Check to ensure the module has a Blue "zl module" symbol on it.
Remove the module from the switch and replace it with a zl module, or
recover the slot with the cover plate. You can remove and replace the module
without having to power down the switch. Call your ProCurve authorized dealer, or
use the electronic support services from ProCurve to get information on supported
Switch zl modules. The modules that are available as of the printing of this manual
are listed on page 1-15.
Diagnosing with the LEDs
Solution
Troubleshooting
5-5