Introducing the ProCurve Series 8200zl Switch
Front of the Switch
LEDs
As described in the following tables, there are LEDs on the switch chassis and
on the switch modules that keep you informed of the status of the switch and
the network connections.
Figure 1-3. Switch Chassis LEDs
Table 1-1.
LEDs
State
Power
On
(green)
Off
Fault
Off
(orange)
1
Blinking
On
Locator
On
Blinking
(blue)
Off
1
The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.
2
The blinking behavior is an on/off cycle once every 0.5 seconds, approximately.
1-4
Power
and Fault
LEDs
Locator LED
Switch Chassis LEDs
Meaning
The switch is receiving power.
The switch is NOT receiving power.
The normal state; indicates that there are no fault conditions on the switch.
A fault has occurred on the switch, one of the switch modules, an individual port, a power
supply, or a fan. The Status LED for the module or other device with the fault will flash
simultaneously.
On briefly at the beginning of switch self test after the switch is powered on or reset. If on
for a prolonged time, the switch has encountered a fatal hardware failure, or has failed its
self test. See chapter 5, "Troubleshooting" for more information.
The Locator LED is used to locate a specific chassis in a area full of chassis. The LED can
be set to be on solid or blink for a specified number of minutes (1-1440). The default is 30
minutes. Use the command "chassislocate".