HP ProCurve Series 8212zl Installation And Getting Started Manual page 58

Installing the Series 8200zl Switch
Hot Swapping Switch Modules
You can reboot the switch by any of the following methods:
■
■
■
Until the switch is rebooted, the module will not operate and the Module
Status LED for the affected slot will continue to flash.
2-32
Pressing the Reset button on the front of the switch.
Unplugging and plugging in the power cord (power cycle). If two power
supplies are installed, both power cords would have to be unplugged.
Issuing the boot command from the switch console CLI, or selecting the
boot Switch option from the switch console menu, the web browser
interface, or ProCurve Manager.