Hardware Diagnostic Tests; Reasons For Resetting The Switch; Methods Of Resetting The Switch - HP ProCurve Series 8212zl Installation And Getting Started Manual

Troubleshooting

Hardware Diagnostic Tests

Hardware Diagnostic Tests

Reasons for Resetting the Switch

Generally, you only need to reset the switch when it needs to recognize a
change in its hardware or software (console) configuration. Some
circumstances in which you will need to reset the switch are:
■
N o t e
■
You do not need to reset the switch when:
■
■

Methods of Resetting the Switch

You can reset the switch by any of these methods:
■
■
■
5-10
Installing a module in a slot that was previously occupied by a different
type of module, the switch must be reset after the new module is installed
so the switch processor can properly initialize and configure the new
module type.
When a module is exchanged for a different type, until the switch is reset
the module will not operate, the Module Status LED (orange) for the slot
will blink, the chassis fault LED will blink simultaneously, and all the LEDs
on the module will stay on continuously.
Changing certain switch configuration parameters through the console
interface. (In this case, the console provides indications when the switch
must be reset for the configuration change to be activated.)
Installing a module in a previously unused slot.
Replacing a module with the same type of module.
pressing the Reset button. On the 8212zl, this is the System Reset button
on the System Support Module. On the 5400zl Series, this is the Reset
button on the Management Module.
power cycling the switch (if both power supplies are being used, you will
have to disconnect both power cords)
issuing the boot command from the switch console CLI, or selecting the
Reset or Boot option from the switch console menu, web browser inter-
face, or ProCurve Manager