Installation Procedures; Summary - HP ProCurve Series Installation And Getting Started Manual

Installation Procedures

Summary

1. Prepare the installation site
ment is properly prepared, including having the correct network cabling
ready to connect to the switch and having an appropriate location for the
switch. See page 2-4
2. Install or remove a yl module
3. Install or remove a transceiver
installed a yl module, you can now install one or two transceivers.
4. Install or remove mini-GBICs
four slots for installing mini-GBICs. Depending on where you will mount
the switch, it may be easier to install the mini-GBICs first. Mini-GBICs can
be installed or removed while the switch is powered on.
5. Verify the switch passes self test
power source and observe that the LEDs on the switch's front panel
indicate correct switch operation. When self test is complete, unplug the
switch.
6. Mount the switch
telco rack, in an equipment cabinet, or on a horizontal surface.
7. Connect the switch to a power source
mounted, plug it into the nearby main power source.
8. Connect the network cables
network cables, connect the network devices to the switch ports.
9. Connect a 620 RPS/EPS
a 620 RPS/EPS with your switch. To do so you must connect the external
power supply using the RPS or EPS cables supplied with the 620 RPS/EPS.
10. Connect a console to the switch
to modify the switch's configuration, for example, to configure an IP
address so it can be managed using a web browser, from an SNMP network
management station, or through a Telnet session. Configuration changes
can be made easily by using the included console cable to connect a PC
to the switch's console port.
At this point, the switch is fully installed. See the rest of this chapter if you
need more detailed information on any of these installation steps.
(page 2-5). Ensure the physical environ-
for some installation precautions.
(optional—page
(optional—(page
(optional—page
(page
(page 2-13). The Switch can be mounted in a 19-inch
(page
(page 2-16). Using the appropriate
(optional—page
(optional—page
Installing the Switch
Installation Procedures
2-7).
2-8). If you have
2-9). The switch has
2-11). Plug the switch into a
2-15). Once the switch is
2-18). You may wish to use
2-22). You may wish
2-3