Table of Contents
Advertisement
Installing the Switch
Installation Procedures
8. Connect the Network Cables
Connect the network cables, described under "Cabling Infrastructure"
2-5), from the network devices or your patch panels to the fixed RJ-45 ports
on the switch or to any mini-GBICs you have installed in the switch.
Using the RJ-45 Connectors
To connect:
Push the RJ-45 plug into the RJ-45 jack
until the tab on the plug clicks into
place. When power is on for the switch
and for the connected device, the Link
LED for the port should light to confirm
a powered-on device (for example, an
end node) is at the other end of the
cable.
If the Link LED does not go on when the
network cable is connected to the port,
see
page
shooting".
To disconnect:
Press the small tab on the plug and pull
the plug out of the jack.
Connecting Cables to mini-GBICs
N o t e
Each of the four mini-GBIC slots is shared with the associated 10/100/
1000Base-T RJ-45 port. If a mini-GBIC is installed in a slot, the associated RJ-
45 port is disabled.
If you have any mini-GBICs installed in the switch, the type of network
connections you will need to use depends on the type of mini-GBICs you have
installed. See the table on
mini-GBIC cabling information.
For mini-GBICs ports, and in general for all the switch ports, when a network
cable from an active network device is connected to the port, the port LED
for that port should go on. If the port LED does not go on when the network
cable is connected to the port, see
in chapter 5, "Troubleshooting".
2-16
"Diagnosing with the LEDs" on
5-4, in chapter 5, "Trouble-
page
off = 1 0 Mbps
Link
1
Mode
3
5
flash = 1 00 Mbps
on = 1 0 00 Mbps
2
4
6
Link
Mode
Unshielded twisted-pair cable:
• Category 3, 4, or 5 for 10 Mbps ports
• Category 5 or better for 100 Mbps ports
• Category 5e or better for 1000 Mbps ports
Maximum distance: 100 meters
Figure 2-9. Connecting an RJ-45.
2-6, and appendix B,
"Switch
"Diagnosing with the LEDs" on page 5-4
(page
PoE-Int egrated 10/1 00/1 000Base-T P orts (1 - 24T) — Ports are IEEE A uto MDI/M
7
9
11
Link
13
Mode
15
8
10
12
14
16
Link
Mode
RJ-45 connector
Ports", for the
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
