Configuring Lacp Mad; Configuring Arp Mad - HP FlexFabric 5700 series Configuration Manual

Configuring LACP MAD

When you use LACP MAD, follow these guidelines:
• The intermediate device must be a device that supports extended LACP for MAD.
If the intermediate device is also an IRF fabric, assign the two IRF fabrics different domain IDs for
•
correct split detection.
Use dynamic link aggregation mode. MAD is LACP dependent. Even though LACP MAD can be
•
configured on both static and dynamic aggregate interfaces, it takes effect only on dynamic
aggregate interfaces.
Configure link aggregation settings on the intermediate device.
•
To configure LACP MAD:
Step
1. Enter system view.
2. Assign a domain ID to the IRF
fabric.
3. Create a Layer 2 aggregate
interface and enter
aggregate interface view.
4. Configure the aggregation
group to operate in dynamic
aggregation mode.
5. Enable LACP MAD.
6. Return to system view.
7. Enter Ethernet interface view
or interface range view.
8. Assign the Ethernet port or
the range of Ethernet ports to
the specified aggregation
group.

Configuring ARP MAD

When you use ARP MAD, follow these guidelines:
Do not configure ARP MAD on VLAN-interface 1.
•
• Do not use the VLAN configured for ARP MAD for any other purpose.
Command
system-view
irf domain domain-id
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
mad enable
quit
•
Enter interface range view:
interface range { interface-type
interface-number [ to
interface-type interface-number ] }
&<1-24>
•
Enter Ethernet interface view:
interface interface-type
interface-number
port link-aggregation group number
24
Remarks
N/A
The default IRF domain ID is 0.
Perform this step also on the
intermediate device.
By default, an aggregation
group operates in static
aggregation mode.
Perform this step also on the
intermediate device.
By default, LACP MAD is
disabled.
N/A
To assign a range of ports to the
aggregation group, enter
interface range view.
To assign one port to the
aggregation group, enter
Ethernet interface view.
Multichassis link aggregation is
allowed.
Also perform this step on the
intermediate device.