Scsi Configuration Utility; Running The Navigator Cd-Rom On A Windows Pc - HP TC4100 Operation And Maintenance Manual

Chapter 3
5. Return switch 4 from On (closed) to Off (open) on the system board's configuration switch block. See
Figure 3-23.
6. Replace the side panel and power up the HP Server tc4100.
7. When you see the message "Incorrect System Configuration", press F2 to run the Setup utility.
8. Make any configuration changes required.
9. Choose the Exit option and save the changes you just made and exit the utility.

SCSI Configuration Utility

If you need to verify or modify SCSI host adapter settings, or if you need to
low-level format SCSI disks or verify SCSI disk media, run the Symbios Configuration utility:
1. Turn on or reboot your system.
2. During system start-up or reset, when the following message appears, press the CTRL and C keys at the
same time.
Press [Ctrl] [C] to start Symbios Configuration Utility
3. Use the arrow keys to move the cursor, press Enter to select an option, and press Esc to exit.
4. To change adapter settings:
• Select an adapter from the list in the main menu.
• Select Adapter Setup. This option configures the SCSI ID setting and other advanced adapter settings.
5. To format a hard disk or change hard disk parameters:
• Select an adapter from the list in the main menu.
• Select Device Selections.
• Select the hard disk to format.
• Select the Format menu option.
For more information, refer to "Information Assistant" on the HP Server tc4100 Online Documentation CD-
ROM.

Running the Navigator CD-ROM on a Windows PC

Using the HP Navigator CD-ROM in any Windows PC does not allow you to perform any configuration tasks,
but it does allow you to view the configuration instructions before or after installing and setting up your HP
Server tc4100. The Navigator CD-ROM will autorun on any PC with Windows 95

Windows NT .
Contents of the Navigator CD-ROM – Windows PC
The Main Menu provides you with options to view and print configuration information. The menu and submenu
buttons are listed here with a brief description for each selection.
•
What's New on the CD – This menu selection provides the part number and version of the CD as well as a
status report about the systems supported by this CD. It also provides the Internet address for the latest
information including release notes about your HP Server tc4100.
•
System README – This file includes the most recent information that was not included in the printed
installation documentation.
•
Guide To Configure Server – This menu selection provides three submenus.
• NOS Installation Instructions - This submenu selection provides you with the necessary instructions to
install the NOS you have selected for this installation.
Installing and Configuring
 
, Windows 98 , or
67