HP TC4100 Operation And Maintenance Manual page 68

Chapter 3
10. Choose "Yes" and press Enter.
Then the HP Server tc4100 reboots.
Clearing CMOS
The Setup Utility provides a method of clearing CMOS from within the Utility. You may alsoclear the CMOS
of the configuration settings using the configuration switch on the system board.
Clearing CMOS via the Setup Utility
1. To clear CMOS from the BIOS Setup utility, press F11 during server POST when prompted to "Press F2
to enter Setup". This will provide advanced features in the Setup utility.
2. From the Exit menu, select "Clear system configuration".
3. Press F10 to save and exit the utility.
Clearing CMOS via the System Board Switches
1. To clear CMOS configurations using the System Board switch, power down the HP Server tc4100 and open
the side panel to gain access to the System Board.
2. On the system board, reset switch 4, on the configuration switch block, from Off (open) to On (closed). See
Figure 3-23 and
Table 3-3. Configuration Switch Block
Switch Number Switch On
1 Not Used
2 Not Used
3
Clear Password
4
Clear CMOS
5 Not Used
6 Not Used
7 Not Used
8 Not Used
3. Power up the HP Server tc4100.
4. When you see a message diaplayed indicating that the configurations have been cleared, power off the HP
Server tc4100.
Table 3-3.
Shaded rectangle
represents the
position of slide switch
Figure 3-23. Configuration Switch Block - Clearing CMOS
Switch Off
Not Used
Not Used
Keep Password
Keep CMOS
Not Used
Not Used
Not Used
Not Used
Open = Off
Closed = On
1
2
3
4
5
6
7
8
Installing and Configuring
66