HP TC4100 Operation And Maintenance Manual page 73

Chapter 4
Table 4-1. POST Error Codes
Code Description
0100 Keyboard error during
POST
0101 Keyboard error
0102 Keyboard controller
error
0103 Keyboard is not
connected
0105 Mouse boot error
0106 Mouse is not
responding
0108 Mouse and Keyboard
connections reversed
Problem/Solution
A key on the keyboard has been pressed during POST of the HP
Server.
To correct this:
1. Ensure nothing is placed on the keyboard and no key is acciden-
tally pressed down.
2. Reboot the server.
3. If the error persists, your keyboard may need to be replaced. Con-
tact your service representative.
The keyboard has reported an error during its self-test.
To correct this:
1. Restart your HP Server.
2. If the error persists, your keyboard may need to be replaced. Con-
tact your service representative.
POST has detected a general failure in the integrated keyboard
controller.
To verify this error:
1. Restart your HP Server.
2. If the error persists, your keyboard may need to be replaced. Con-
tact your service representative.
POST has detected the keyboard is not connected.
To correct this:
1. Verify the keyboard connector is firmly connected.
2. Reboot the server.
3. If the problem persists, your keyboard cable may be damaged or
your keyboard may need to be replaced. Contact your service rep-
resentative.
The system board has detected a mouse error during POST.
To correct this:
1. Clean the mouse and its moving ball as described in the User's
Guide.
2. If the problem persists, your mouse may need to be replaced. Con-
tact your service representative.
The system board has detected the mouse is not responding.
To correct this:
1. If the mouse has just been removed, press Esc to automatically
validate the change.
2. Otherwise, verify the mouse connector is firmly connected.
3. If the problem persists, your mouse may need to be replaced. Con-
tact your service representative.
POST has detected the mouse and keyboard connections are reversed.
To correct this:
1. Turn the server off.
2. Swap the mouse and keyboard connections.
3. Turn on the server power and reboot the server.
Error Messages
71