Connecting External Scsi Devices; Memory Modules; Introduction - HP TC4100 Operation And Maintenance Manual

Chapter 3
Pedestal

Connecting External SCSI Devices

An accessory can be ordered for the HP Server tc4100 which will provide an external SCSI connection from
the SCSI A connector embedded on the system board.
A SCSI disk controller board or a DAC board inserted into one of the PCI slots may also provide an external
SCSI connection. The last device in the SCSI chain of external devices must be terminated.
CAUTION Do not use high voltage differential (HVD) SCSI devices on any of the SCSI channels or
damage will occur. The HVD SCSI devices are not supported. Use only Single-Ended
(SE) or Low-Voltage Differential (LVD) devices to connect to the external connectors.

Memory Modules

Introduction

This section provides the instructions for installing and removing DIMMs on the system board in the HP Server
tc4100. The video memory comes with 8 MB standard and cannot be upgraded.
NOTE The EDO DIMMs and PC 100 SDRAM DIMMs from earlier HP Server tc4100 models
will fit into the DIMM slots in the Server, but the EDO DIMMs and PC 100 SDRAM will
not function properly. Use only 133 MHz SDRAM DIMMs acquired from HP.
To ensure you have the correct DIMMs before installation, refer to one of the following for a list of qualified
DIMMs:
•
Technical Reference Label inside the HP Server tc4100's top or side coverHP Order Assistant on the HP
web site at:
http://www.hp.com
•
Information Assistant on the HP Server tc4100 Online Documentation
CD-ROM
•
HP Customer Service
P1 CD-ROM
P2 Location
P3 Location
Rack Mount
Figure 3-12. SCSI Tape Drives Supported Location
Installing and Configuring
i
R1 Location
R2 Location
R3 CD-ROM
39