Permobil C500 Service Manual page 32

Seat lift
Electric Seat Lift
Removal
1. Raise the seat lift to its highest position. To
raise the seat on a chassis with an electric
seat lift that does not work normally because
the batteries are discharged or the adjustment
device is defective, see page 30.
2. Switch off the main power switch on the
control panel.
3. Set the main fuse to the Off position.
4. Remove the seat lift cover and chassis cover -
see page 7.
5. Remove the seat.
m
NB
The seat is heavy. Two people should therefore lift it. Be
careful with the cabling.
6. Disconnect the seat lift cabling - see page 34.
7. Remove the four screws which secure the seat
lift.
Fitting
1. Identify the holes for fitting the seat lift on the
chassis - see the figure. Older chassis models
may not have the two lower holes. The chassis
must then be adapted - see page 35.
2. Identify the holes on the seat lift for the
relevant configuration - see page 33.
3. Fit the lower fixing screws and appropriate
washers - see page 33. When fitting a seat lift
to an older, adapted chassis without fixed nuts,
use the nuts supplied with the appropriate
washers.
4. Fit the upper fixing screws and appropriate
washers and nuts - see page 33.
Tighten the screws holding the seat lift in place
with a torque wrench.
Tightening torque: 24 Nm.
m
NB
Ensure that the holes on the seat lift are placed right over the
corresponding holes on the chassis - see page 33.
5. Connect the seat lift cabling - see page 34.
6. Refit the seat.
7. Refit the covers - see page 7.
8. Set the main fuse to the On position.
Main fuse/battery isolator (On/Off).
The seat plates on the PS seat are
mounted with four screws.
32
On
Off