Removal - Permobil C500 Service Manual

Fixed seat post

Removal

1. Switch off the main power switch on the control
panel.
2. Put the circuit breaker in the "OFF" position. It is
accessed through a hole in the chassis cover;
see page 45.
3. Raise the seat to its highest postion, see page
38.
4. Remove the seat lift cover and the chassis
cover, see page 7.
5. Remove the seat and if equeipped, the seat tilt.
m
NOTE
Because the seat is heavy, it should be lifted by two persons. Be
careful with the cabling.
6. Remove the fixed seat tube. It is attached with
four screws, see fig.
The upper attachment screws are accessible
from the the battery boxes. Open the battery
covers and pull each battery out just enough
to get access to the screws through the holes
in the chassis.
7. Lift the seat post straight up out of the chassis.
Fitting
Fit the fixed seat tube in the reverse order.
The Fixed seat tube is attached with four screws.
The Seat Post's lower attachment screws.
The Seat Post's upper attachment screws.
39
Fixed seat post