Rear Wheels - Permobil C500 Service Manual

Rear wheels

Rear wheels
Removal
1. Turn off the main power switch on the control
panel.
2. Lift the wheelchair chassis and support it on
blocks so that the wheel is off the ground.
3. Remove the hucap (1).
4. Remove the screw (2) and the washer (3).
5. Pull the wheel off the shaft.
Fitting
1. Check that the wheel shaft and rim are
undamaged. Clean as necessary to remove
dirt and rust. Replace damaged parts.
2. Fit the wheel onto the axle with the use of
hand force only. Make sure the rim is fully
seated upon the axle.
3. Fit the washer (3) onto the screw (2) and
secure the wheel.
Use a torque wrench to tighten the bolt to 17.7
ft-Ibs (24Nm).
m
NOTE
Do not use a Pneumatic impact wrench.
m
WaRNINg
The bolt must be used once only. Removed bolt is not
allowed to be refitted.
Other types of bolts or washers are not to be used.
Do not use any other type of thread lock.
Rear wheel
2 3
1
Fitting of rim.
Pos.
1 Hubcap
2
Bolt, ISO 4017 M8x16 8.8 Fe/Zn 5 C1 / Locking
coat DIN 267-28
3
Washer, 8.5x23x3
4 Rear heel
12
4
Description