Seat Lift Motor - Permobil C500 Service Manual

Seat lift
Seat lift cabling
Removal
1. Disconnect the seat lift cabling by disconnecting the contacts on the cables that go to the General
Module - see page 34. Disconnect the contacts for the seat lift motor as well.
2. Remove the seat lift sensors, which are held in place by one screw each. Note the positions of the
sensors for subsequent fitting - see figure.
Fitting
Fit in the reverse order.
Positions of the sensors on the seat lift.

Seat lift motor

Removal
1. Disconnect the seat lift cabling from the motor. Note the positions of the cables - see figure.
2. Remove the motor. It is held in place by three screws - see figure.
Fitting
Fit in the reverse order.
Seat lift motor's connection contacts.
Sensor fitted on the seat lift.
The motor is held in place by three screws.
36