Gs1 Databar Expanded Set Length 1 - Datalogic QD2100 Product Reference Manual

Symbologies
GS1 DataBar Expanded — cont.

GS1 DataBar Expanded Set Length 1

This feature specifies one of the barcode lengths for
Control
fixed length if in
ly.
The length can be set from 1 to 74 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 74). Pad the number with leading
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT GS1 DataBar EXPANDED LENGTH 1 SETTING.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 19. GS1 DataBar Expanded Length 1 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT GS1 DataBar EXPANDED LENGTH 1SETTING
Scan Two Characters From
4
Appendix E, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
148
. Length 1 is the minimum label length if in
Fixed Length
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
01 Character
'0' and '1'
GS1 DataBar Expanded Length
Variable Length
Mode. Length includes the barcode's data characters on-
Appendix E,
for some examples of how to set this feature.
Table 19
EXAMPLES
07 Characters 52 Characters
'0' and '7'
Mode, or the first
Keypad, that represent
74 Characters
'5' and '2' '7' AND '4'
QuickScan® QD2100