Code - Datalogic QD2100 Product Reference Manual

Interleaved 2 of 5 (I 2 of 5) — cont.
I 2 of 5 Set Length 1
This feature specifies one of the barcode lengths for
the minimum label length if in
Fixed Length
The length can be set from 2 to 50 characters in increments of two.
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50). The length must be an even num-
2. Pad the result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT I 2 of 5 LENGTH 1 SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 25. I 2 of 5 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
Pad with leading zeroes to yield
2
two digits
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT I 2 of 5 LENGTH 1 SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. The length includes the barcode's check and data characters.
ber.
etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
2 Characters
02
'0' and '2'
I 2 of 5 Length Control
Mode, or the first fixed length if in
Variable Length
Appendix E,
for some examples of how to set this feature.
Table 27
EXAMPLES
6 Characters 14 Characters
06
'0' and '6'
Interleaved 2 of 5 (I 2 of 5)
. Length 1 is
Keypad, that represent
50 Characters
14 50
'1' and '4' '5' AND '0'
195