Standard Defaults - Datalogic QD2100 Product Reference Manual

The most common configuration settings are listed in the "Default" column of
The settings in this table are as applied to a standard RS-232 interface. See
a listing of default exceptions to this list as appled to other interface types. Page references
are also provided for feature descriptions and programming barcodes for each parameter.
A column has also been provided for recording of your preferred default settings for these
same configurable features.
Table 37. Standard Defaults
General Features
Double Read Timeout
Label Gone Timeout
Power On Alert
Good Read: When to Indicate
Good Read Beep Type
Good Read Beep Frequency
Good Read Beep Length
Good Read Beep Volume
Good Read LED Duration
Scan Mode
Stand Mode Triggered Timeout
Scanning Active Time
Flash On Time
Flash Off Time
Stand Mode Sensitivity
Green Spot Duration
Product Reference Guide
Parameter
Appendix B

Standard Defaults

Default Your Setting
0.4 Second
160 ms
4 Beeps
After Decode
Mono
Medium
80 ms
High
LED on until
next trigger pull
Trigger Single
0.5 Seconds
5 Seconds
1 Second
600 ms
Medium
300 ms
.
Table 37
for
Table 38
Page Number
17
19
21
22
23
24
24
26
27
29
31
33
35
37
39
40
271