Datalogic QD2100 Product Reference Manual page 167

Datalogic 2 of 5 — cont.
Datalogic 2 of 5 Set Length 1
This feature specifies one of the barcode lengths for
Length 1 is the minimum label length if in
length if in
acters.
The length can be set from 2 to 50 characters in increments of two.
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50). The length must be an even num-
2. Pad the result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT I 2 of 5 LENGTH 1 SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 27. Datalogic 2 of 5 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
Pad with leading zeroes to yield
2
two digits
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT Datalogic 2 of 5 LENGTH 1 SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. The length includes the barcode's check and data char-
Fixed Length
ber.
etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
2 Characters
02
'0' and '2'
Datalogic 2 of 5 Length Control
Variable Length
Appendix E,
for some examples of how to set this feature.
Table 27
EXAMPLES
6 Characters 14 Characters
06
'0' and '6' '1' and '4'
Datalogic 2 of 5
Mode, or the first fixed
Keypad, that represent
50 Characters
14 50
'5' AND '0'
.
205