Datalogic QD2100 Product Reference Manual page 200

Symbologies
Code 11 — cont.
Code 11 Set Length 2
This feature specifies one of the barcode lengths for
is the maximum label length if in
in
Fixed Length
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50 — or 0 to ignore this length). Pad
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT CODE 11 LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 32. Code 11 Length 2 Setting Examples
STEP ACTION
Desired Setting (pad with leading
1
zeroes)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 11 LENGTH 2 SETTING
Scan Two Characters From
4
Appendix E, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
238
Mode. Length includes the barcode's check and data characters.
the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
00 (Ignore This
Length)
'0' and '0'
Code 11 Length Control
Mode, or the second fixed length if
Variable Length
Appendix E,
for some examples of how to set this feature.
Table 32
EXAMPLES
07 Characters 15 Characters
'0' and '7' '0' and 'F'
. Length 2
Keypad, that represent
50 Characters
'3' AND 2'
QuickScan® QD2100