Network Connection; Power Connection; Figure 2-10 Connecting Adam-4577 Series To The Hub - Advantech ADAM-4577 User Manual

2.2.2
There are two ways to use the 10 Base-T Ethernet connector located
on the ADAM-4577 :
1.For Local Area Network (LAN) applications using the
ADAM-4577, you will simply plug one end of your Ethernetcable into
the 10 Base-T connector, and the other end into the hub connected to
your network.
2.When installing and configuring, you will find it convenient to hook
the ADAM-4577 directly to your computer's Ethernet card. To do this
you will need to use a "crossed-cable", such as the one supplied with
your server.
Cabling requirements for the Ethernet side
Use an RJ-45 connector to connect the Ethernet port of the ADAM-
4577 to the network hub. The cable for connection should be Category
3 (for 10Mbps data rate) UTP/STP cable, which is compliant with EIA/
TIA 586 specifications. Maximum length between the hub and any
ADAM-4577 is up to 100 meters (ca. 300 ft).

Figure 2-10 Connecting ADAM-4577 series to the hub

2.2.3
You should take the following steps to connect ADAM-4577 power.
1.Connect the power cable to 2-pin connector
2.Connect power cable to power adapter
If the ADAM-4577 is working properly, the green power LED will light
16 ADAM-4577 User's Manual

Network Connection

Dual Speed Hub

Power Connection

Category 3
EIA/TIA 568
UTP Cable
ADAM-4577
100m
ADAM-5510