Switch On The Dvr - ESP DIGI-VIEW 4 System Installation And User Manual

Switch On the DVR

Before turn on the power, please make sure Video Format is in right position
NTSC Area : North America, Japan, Philippines, Taiwan & etc.
PAL Area : Europe, South America, Australia, Mid-East & Africa
Asian Countries most use PAL like Indonesia, Thailand, Malaysia and etc.
Once the DVR and HDD have been properly installed (please refer to pages
3 ~ 8 for further details about DVR installation) the unit is ready to record
and display. Apply power and switch on.
Following power on, the DVR takes a few seconds checking the HDD. If
a new hard drive is detected, DVR will format the drive automatically.
One of the below messages are displayed:
HDD Checking .....
Master 160072 MB.
Press Pause button 6 times will restore the unit to factory settings. "DVR
Reset Completed" message will be displayed on the monitor and requests a
restart of the DVR.
HDD Checking .....
Master
160072MB
New HDD format completed
Slave
No HDD Detected