Start-Up Problems - HP xp8010 series Reference Manual

Troubleshooting

Start-up problems

If no lights or sounds turn on:
If nothing is projected, but the projector seems to start up:
If the projector makes a "ticking" sound, if the projector lamp does not
turn on, and if warning lamp light is on:
72
❏
Ensure that the power cable is securely connected to the projector
and the other end is plugged into an outlet with power.
❏
Verify the main disconnect switch is turned on (1), not off (0).
❏
Verify that lid of the projector is latched shut.
❏
Press the power button again.
❏
Reset the projector by turning the main disconnect switch off,
wait 60 seconds, then turn it on again.
❏
Ensure the lens cap has been removed.
❏
If the lamp indicator is on, replace or reinstall the lamp module.
❏
If the temperature indicator is on, turn off the projector and allow
it to cool before restarting it. If the warning lights turn on again,
contact HP for assistance.
❏
The projector lamp is too hot to light. Turn the projector off and
wait for it to cool before turning it on again.
❏
The projector lamp is not making a good connection. Turn off the
projector and allow it to cool. Then remove and reinstall the lamp
module.
❏
The projector lamp has reached the end of its life. Replace the
lamp.
Reference Guide