HP xp8010 series Reference Manual: To Replace The Lamp Module

Hewlett-packard projector reference guide.
Hide thumbs

Advertisement

To replace the lamp module

Å
WARNING:
When the lamp nears its end of life, it might break. To reduce the risk of injury, be careful
when removing the lamp cover as broken glass might be present. For a ceiling
installation, wear goggles and gloves when removing the lamp module. If the lamp is
broken, contact HP about repairs that might be required.
Wait 30 minutes before opening the lamp cover and removing the lamp module because
the lamp assembly operates at a very high temperature. If you open the lid during
cool-down, you increase the cool-down time because the lid safety switch disconnects
power and turns off the fan.
1. Turn off the projector and allow it to cool for 30 minutes.
2. Open the lid
3. Use a Phillips screwdriver to loosen the three screws
4. Lift the handle
Ä
CAUTION: Do not touch any internal parts of the projector. You could easily damage
delicate or precision parts.
5. Insert the new lamp module and tighten the three screws.
Reference Guide
1
on the top of the projector.
3
and unplug the lamp module
2
holding the lamp module.
4
from the projector.
Maintenance
69

Advertisement

   Related Manuals for HP xp8010 series

This manual also for:

Xp8020, Xp8000 - digital projector

Comments to this Manuals

Symbols: 0
Latest comments: