HP xp8010 series Reference Manual: To Connect Control Equipment

Hewlett-packard projector reference guide.
Hide thumbs

Advertisement

To connect control equipment

9-pin serial cable
2.5-mm (3/32-in) to 3.5-mm (1/8-in) stereo mini-phone cable
3.5 × 1.3-mm DC power cable
In some installations, the projector might not be visible to the remote control, such as
for rear projection. Use one of these solutions to enable the remote control to work:
Use a remote control extension. Plug its cable into the remote connector on the
projector. Install the receiver in the room with the presenter.
Wire the remote control to the projector. Construct a cable with a 2.5-mm
(3/32-in) stereo mini-phone jack at one end and a 3.5-mm (1/8-in) stereo
mini-phone jack at the other end. Plug the small connector into the remote control
and the large connector into the remote connector on the projector.
Reference Guide
Installation and Setup
33

Advertisement

   Related Manuals for HP xp8010 series

This manual also for:

Xp8020, Xp8000 - digital projector

Comments to this Manuals

Symbols: 0
Latest comments: